XNUMX. Before installing the servo planetary reducer, confirm whether the motor and reducer are intact, and strictly check whether the dimensions of the parts connected to the motor and reducer match. Here are the dimensions of the positioning boss of the motor, the input shaft and the groove of the reducer. And fit tolerances.

　　XNUMX. Unscrew the screw on the dust-proof hole on the outer side of the reducer flange, adjust the PCS system clamping ring to align the side hole with the dust-proof hole, and insert the inner hexagon to tighten.After that, remove the motor shaft key.

　　XNUMX. Naturally connect the motor and the reducer.When connecting the servo planetary reducer, the concentricity of the output shaft of the reducer and the input shaft of the motor must be the same, and the outer flanges of the two must be parallel.If the center is inconsistent, it will cause the motor shaft to break or the gear of the reducer to wear.

　　In addition, during installation, it is strictly forbidden to hit with a hammer, etc., to prevent excessive axial or radial force from damaging the bearings or gears.Be sure to tighten the mounting bolts before tightening the tightening bolts.

　　Before installing the servo planetary reducer, wipe off the rust-preventing oil on the motor input shaft, positioning boss and the connection part of the reducer with gasoline or zinc-sodium water.Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear.

　　Before connecting the motor to the reducer, the keyway of the motor shaft should be perpendicular to the tightening bolt.To ensure uniform force, first screw on the mounting bolts at any diagonal position, but do not tighten, then screw on the other two diagonal mounting bolts, and finally tighten the four mounting bolts one by one.

　　Finally, tighten the tightening bolts.All tightening bolts of the servo planetary reducer need to be fixed and checked with a torque wrench according to the marked fixed torque data.The correct installation between the reducer and mechanical equipment is similar to the correct installation between the reducer and the drive motor.The key is to ensure that the output shaft of the reducer is consistent with the concentricity of the driven part of the shaft.