1. The fixation of the right-angle planetary reducer is very important to ensure stability and firmness. Generally speaking, we should install the reducer on a horizontal foundation or base. At the same time, the oil in the oil drain groove should be able to drain, and the cooling air circulation should be smooth.If the speed reducer is not fixed well and the foundation is unreliable, it will cause and vibrate. It will also cause unnecessary damage to the bearings and gears.

　　2. When installing the transmission parts on the output shaft of the reducer, you must pay attention to the gentle operation. It is forbidden to use hammers and other tools for rough installation. It is best to use the assembly fixture and the internal thread of the end shaft to install the The transmission parts are pressed into the reducer, which can protect the internal parts of the reducer from damage.

　　3. When installing the right-angle planetary reducer, pay special attention to the centering of the transmission center axis, and the centering error cannot exceed the use compensation amount of the coupling used in the reducer.After the reducer is centered according to the requirements, a more ideal transmission effect and a longer service life can be obtained.

　　4. When necessary, the transmission coupling of the reducer should be equipped with protective devices, such as protrusions on the coupling or the use of gears or sprocket transmission, etc. If the output bearing is subjected to a large radial load, a reinforced type should also be selected.

　　5. Under any circumstances, it is not allowed to use a hammer to knock the belt pulley, coupling, pinion or sprocket into the output shaft, which will damage the bearing and shaft.

　　6. The right-angle planetary reducer can only be installed on a flat, shock-absorbing, and torsion-resistant support structure.